![]() You must have a great and positive attitude, clean driving record, on time/punctual, team player and have a great ability to learn. We are a highly motivated and focused team dedicated to delivering the highest quality of work to our clients. We are looking for someone who can install window tint at our high standard of quality. We are looking for someone with experience who has a positive attitude and is always willing to learn and adapt to a wide range of vehicles and techniques. Pro Tint of Orlando specializes in high end new car paint protection, window tinting, vinyl wraps and ceramic coating installations. Pro Tint of Orlando is one of the largest 3M Pro Shops in the Southeast US. ![]() We are looking for window tinters in full and part-time capacities. However even our Llumar Pro Select shop here avoids them and will not do them they struggle so bad with them. This is not a window meant for the beginner level. This will help you get adhesion when you put it on the inside. Wipe the gray residue off with a towel before you clean or squeegee. ![]() Another thing you can do is all along the border and the matrix at the top you can sand with 1000 grit wet sandpaper. It gives me alignment and I don't have to worry about gaps. Usually I cut both on the outside and then adjust the one that will not fit on the inside. When you get all that done I then cut one side of the defroster elements and you can either cut the other one or wait till you put on the inside and hand cut it to fit. If that is the case then you will need to do a bit of shrinking at the bottom in that area. There are a few windows I have done where at the very bottom on the passenger side it will not stay laid down on the glass. On the top you have maybe 5 seconds of shrinking. You should have nothing.not one finger.to shrink around the bottom and sides. Pull all of your fingers and slack around the bottom and towards the top. I soap shrink so I put a little too much soap on the window and while it is still sticky I attempt this. What I do is tack in the middle a place a bit larger than my fist. ma'am makes reference to it when he says to pull across the bottom. ![]() This is an old school rear glass and it must be done "old school." In the old days before we shrank that much it was all about tension. Correct when he says solar gard is not really sticky at all. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |